Europe's Leading 3D-Printing Store in High Quality Builder3D-Printers and FormFutura Filaments & Pellets . All for Professionals, Artists & Hobbyists

EasyCork™ - Dark

New product

EasyCork is a lightweight cork-filled PLA-based filament which is gravimetrically filled with approximately 30% cork fibres. The gravimetric filling with relatively lightweight cork fibres means that EasyCork has extremely high volumetric cork filling properties, allowing you to 3D print beautiful objects with great cork-like aesthetics and cork-like properties such as being lightweight and impact resistant.

Mehr Infos

€ 31,95 inkl. MwSt.

  • 1.75mm
  • 2.85mm
  • 500 gram
  • 50 gram (Sample Coil)

Mehr Infos

EasyCork is a very easy to print material as it is based on our EasyFil PLA compound and the 30% gravimetrical filling with cork fibres make the filament absolutely warp-free.

Unique features

  • High cork filling

    • Real cork feel, look and smell

  • Very easy to print

    • Warp-free printing

    • Great thermal stability and filament flowing behaviour

    • Perfect first- and inter-layer adhesion

    • Can be printed at high printing speeds

  • Lightweight and impact resistant

General printing guidelines *

Nozzle size: ≥ 0.4mm Layer height: ≥ 0.25mm Flow rate: ± 100%
Print temp: ± 210 - 260° C Print speed: High Retraction: Yes ± 5mm
Heat bed: ± 0 - 60° C Fan speed: 50-100% Experience level: Beginner

*) Above displayed settings are meant as guidance to find your optimal print settings. These ranges in settings should work for most printers, but please do feel free to experiment outside these ranges if you think it is suitable for your printer. There are a lot of different type of printers, hot-ends and printer offsets that it is extremely difficult to give an overall one-size-fits-all setting.

Filament length

ρ: 1.027 g/cc 50 gr coil 0.5 Kg spool
Ø 1.75mm ± 20.2m ± 202m
Ø 2.85mm ± 7.6m ± 76m

Nozzle cleaning

When printing with filled/composite filaments it is recommended to clean your nozzle immediately after printing by feeding 15-20cm PLA filament through your nozzle. This will make sure that any potential fillers are flown out of your nozzle. It is even better to use glow in the dark PLA as the extremely hard phosphorous particles are much more likely to scrape out residual waste from your nozzle.

Product export information

HS Code: 39169090 Description: Monofilament Country of origin: the Netherlands

Compliance *

This filament is compliant to below listed directives and regulations.

  • RoHS directive 2011/65/EC

  • REACH directive 1907/2006/EC

*) This declaration of conformity to directives and regulations is prepared according to our present standard of knowledge and may be amended if new cognitions are available and applies only for the above described products.

Zubehör

4 andere Produkte der gleichen Kategorie:

Herunterladen

TDS EasyCork™

Technical Data Sheet EasyCork™

Herunterladen (80.75k)

MSDS EasyCork™

Material Safety Data Sheet EasyCork™

Herunterladen (209.88k)